WFE525S0JZ Error Codes — Whirlpool Oven
🏷️ Model: WFE525S0JZ 📅 Production: 2019–present 🔥 Type: Oven
5.3 cu ft freestanding electric range. F3-E0 (open oven sensor) is the most common code; the sensor is a 15-minute DIY replacement.
Most Common Codes on the WFE525S0JZ
All Other Whirlpool Oven Codes
The WFE525S0JZ can also display any of the standard Whirlpool oven codes:
F2-E1 Keypad/touchpad disconnected from control board F3-E1 Oven temperature sensor short circuit F3-E2 Oven over-temperature — temp exceeded safe limit F5-E0 Door switch failure — latch not sensing door position F5-E1 Self-clean door latch failure — lock timeout F1-E0 EEPROM communication error — control board memory fault F1-E1 EEPROM checksum error — corrupted control memory F1-E2 UL A/D error — microprocessor analog-to-digital fault F1-E4 Model ID error — control not configured for this model F1-E5 Calibration shifted — stored temperature calibration out of range F1-E6 Latch signal mismatch — door latch feedback disagrees with control F2-E5 Cancel key drive line open — control panel fault F2-E6 Cancel key drive line open — control panel fault (variant) F4-E1 Meat probe defect — temperature probe fault F6-E0 Return line not connected — control wiring fault F7-E1 Common switch wire defective — function key fault F0 Control board failure F1 Control board failure F5 Control failure — door/latch circuit F7 Function key stuck or shorted F8 Control board failure F2 Oven temperature too high — over-temperature fault F3 Open oven temperature sensor — sensor circuit open F4 Shorted oven temperature sensor — sensor reading short F9 Door latch fault — self-clean lock circuit F1-E9 Control board software fault — stack overflow F1-E3 Wiring harness / cavity size mismatch
💡 Tip: Your model's serial sticker (door frame, rim, or back panel) confirms the exact
model number. Codes can differ between revisions of the same model line — if a code on your display
isn't listed here, check the
full Whirlpool oven code list.