WFG320M0BS Error Codes — Whirlpool Oven
🏷️ Model: WFG320M0BS 📅 Production: 2016–present 🔥 Type: Oven
5.1 cu ft freestanding gas range. Keypad codes (F2-E0/E1) usually mean moisture or heat damage to the membrane switch above the oven vent.
Most Common Codes on the WFG320M0BS
All Other Whirlpool Oven Codes
The WFG320M0BS can also display any of the standard Whirlpool oven codes:
F2-E1 Keypad/touchpad disconnected from control board F3-E0 Oven temperature sensor open circuit F3-E2 Oven over-temperature — temp exceeded safe limit F5-E1 Self-clean door latch failure — lock timeout F9-E0 Door latch during lock function — latch system fault F1-E0 EEPROM communication error — control board memory fault F1-E1 EEPROM checksum error — corrupted control memory F1-E2 UL A/D error — microprocessor analog-to-digital fault F1-E4 Model ID error — control not configured for this model F1-E5 Calibration shifted — stored temperature calibration out of range F1-E6 Latch signal mismatch — door latch feedback disagrees with control F2-E5 Cancel key drive line open — control panel fault F2-E6 Cancel key drive line open — control panel fault (variant) F4-E1 Meat probe defect — temperature probe fault F6-E0 Return line not connected — control wiring fault F7-E1 Common switch wire defective — function key fault F0 Control board failure F1 Control board failure F5 Control failure — door/latch circuit F7 Function key stuck or shorted F8 Control board failure F2 Oven temperature too high — over-temperature fault F3 Open oven temperature sensor — sensor circuit open F4 Shorted oven temperature sensor — sensor reading short F9 Door latch fault — self-clean lock circuit F1-E9 Control board software fault — stack overflow F1-E3 Wiring harness / cavity size mismatch
💡 Tip: Your model's serial sticker (door frame, rim, or back panel) confirms the exact
model number. Codes can differ between revisions of the same model line — if a code on your display
isn't listed here, check the
full Whirlpool oven code list.